Tips and Tricks for Garage Door Repair

Overhead garage doors, regardless of whether they swing up in a single solid piece or roll in multiple sections should be operated on torsion springs. Garage doors run on metal tracks that are positioned on the walls of the garage. Torsion springs are installed to generate and release the power to lift or lower the garage door. In case, when the garage door has minor difficulty, the repairing solution can be fairly simple. But if your garage door is facing major troubles, you should hire a professional garage door technician such as, Jacksonville Garage Door Repair to bring back its functionality. Here are some helpful techniques to get your project started.  

Start your project by inspecting the metal tracks. Have a look at the mounting brackets to check if there are loose components inside them. If the screws and bolts are tightened and secured properly at the brackets, it means that they are in a good working position. When the garage door is closed, inspect each track to find out the flat spots, crimps, or dents on the tracks. If you found any damage, pound it out using a rubber mallet or plastic hammer. Badly damaged tracks should be replaced immediately.

In the next step, examine the tracks of the garage door to make sure that they are aligned correctly. Horizontal tracks should position slightly downward. In the case of roll-up garage door, the vertical tracks should be plumb properly. Garage door tracks must be placed at the same height on both walls of the garage door. if you noticed that tracks are not aligned correctly, you just lose the screws holding the mounting brackets and tap them gently into the correct position. Recheck the alignment and then tighten the screws.  

A good way to avoid these problems is to clean the garage door tracks and panels regularly using a mild household cleaner in order to remove accumulated dirt and grease. Don’t forget to clean the rollers and wipe them out to make them dry. You should lubricate all the moving parts using light silicone spray or powdered graphite. Make sure that you don’t forget the rollers and pulleys in the system while lubrication.

You should check the garage door to find out the loose or damaged hardware. In the swing-up models, check the plates where the springs are mounted in order to ensure that they are tightened to screws. You should check the hinges that hold the multiple sections together. They should be tightened or replaced accordingly. Have a look at torsion springs. On swing-up garage doors, the torsion springs on each side are hooked into holes or notches. If torsion adjustment is required, then shift the spring hook to the next notch or hole. In the roll-up models, the torsion springs are placed on each side which is operated by cables using a simple pulley system. To adjust the torsion, you just need to pull the cable through the plate above the garage door and knot the end to maintain the tension.  

Hopefully, now you have a better idea of what to look for when you experience a problem with your garage door. Don’t forget to call a professional garage door company if you run into something you don’t understand because the garage door system can be rather dangerous to handle.

How to Install a Garage Door Opener
Garage Doors Openers – Getting the Right One for Your House

Follow Us